any GT28 stage 3 a4's with upgaded tip with around 390chp??

[Auditude2.0T]

I'm building a stage 3 b7 with a built tip around 390-400chp. Anyone with a similar setup on a b6 do any 1/4 mile runs?? Thanks

[dougyfresh]

I am working on one with a fellow AZ B6 1.8T user. We're working on a plan for the whole she-bang so we haven't done anything physically to the car yet. It will be a major transformation of his car though. Should have 'her running by the end of the winter.

I know a few 3.0 guys have upgraded TIPs.

[Exanimas]

RLB6 supposedly has broken 300awhp with his GT2871 setup, but he has yet to post the dynos as far as I know. I'd shoot him a PM if I were you.

[vinny.dtw]

I honestly doubt RLb6 is running 300awhp, without meth or race gas. With that being said, I think TIP's really rob the car of power, and i'm interested in what the OP with the B7 is putting down. I need to get my car dialed in and log...Fock

[Auditude2.0T]

I put down 220whp 255wtq with software/exhaust/intake/fp/fmic

[dougyfresh]

I put down 220whp 255wtq with software/exhaust/intake/fp/fmic

From what I've seen the FSI motors make a lot more power than the older 1.8T non-FSI configuration (which makes sense given its newer technology). Be careful comparing numbers.

[vinny.dtw]

considering I have a GTRS and make less then him on a mustang dyno... I dont know. His measy little K03, probably has higher peak hp...but I hope my hp/tq curve is better. We shall see though, hopefully i can get everything resolved.

[dougyfresh]

considering I have a GTRS and make less then him on a mustang dyno... I dont know. His measy little K03, probably has higher peak hp...but I hope my hp/tq curve is better. We shall see though, hopefully i can get everything resolved.

Don't take your results as gospel, we haven't ironed out your system yet. There's a lot more power in your car than your recent dyno sheet shows.

[vinny.dtw]

^Hope so.