Stock Exhaust

[jrodpikap]

What's the best (cheapest) place to find a new OEM Exahust (catback)...or a relatively in-expensive aftermarket (sub $900.00).

[geeky]

For a aftermarket exhaust under 900.00 check your local craigslist or you could even get a Custom turbo back made at most muffler shops for under 500/600 dollars.

[black99.5a4]

I got custom 2.5" tubing with a stainless magnaflow with 2 3" tops that fill the hole in the bumper perfect for 238 installed. top notch mennonite work.

work was performed at red run exhaust in ephrata, pa about 45 mins from you.

[zrowcool]

for under 900 you can get quite a few. APR, Borla, Neuspeed, Milltek if you find it on sale. Theres a bunch in that price range. You can also have a custom one made with a magnaflow mufflers for about half that.

[Don Supreme]

What's the best (cheapest) place to find a new OEM Exahust (catback)...or a relatively in-expensive aftermarket (sub $900.00).

I have an oem exhaust for a manual, 1.8t quattro. Its from my 2000 in fact.

Its not new, and I will not ship it.

PM me if interested.

[jrodpikap]

Gonna have to go the custom route...sounds like that is the best value and as long as it's not too loud, i'm sold.

I have an oem exhaust for a manual, 1.8t quattro. Its from my 2000 in fact.

Its not new, and I will not ship it.

PM me if interested.

[le91688]

lol my magnaflow setup was 240 by menonites...

Gehman's exhaust repair
717-445-7343
located near Reading PA

[tdn]

Make sure you emphasize that you don't want it loud. I have the milltek exhaust for our cars, but went custom before hand. I told the guy I wanted it quiet.. but my definition of quiet is COMPLETELY different than his. Had to go back a second time, even then it was still too loud for me. My milltek with a test pipe is perfect.

[VTAudiA4]

http://www.lmperformance.com/7049/95.html

$650 shipped Borla

I got mine here. They were super nice and shipped it quickly. Just make sure they have it in stock first.

[oneohone]

I got custom 2.5" tubing with a stainless magnaflow with 2 3" tops that fill the hole in the bumper perfect for 238 installed. top notch mennonite work.

work was performed at red run exhaust in ephrata, pa about 45 mins from you.

Damn, this is a good deal!

[jrodpikap]

Sounds like a winner, i'll call them on Monday, but do they stock the Magnaflows? And what model did you end up with, I want mine to be as quiet as possible. Was that a full cat-back setup?

I got custom 2.5" tubing with a stainless magnaflow with 2 3" tops that fill the hole in the bumper perfect for 238 installed. top notch mennonite work.

work was performed at red run exhaust in ephrata, pa about 45 mins from you.