Drivers seat pinout?

**nimski62** · 12-17-2008 06:35 PM

Tried searching, and my drivers side seat has no power. I just want to give it direct power and get it working, because there are 3-4 positive connections on the seat connector.. want to know whats what. possible?

**derleicaman** · 12-17-2008 08:09 PM

Don't understand the question. You have a 3.0 with power seats with no power going to them? Or, do you have manual seats and want to run power? There are 4 sockets below the seat in the floor which control different things (power seats, seat memory, airbags, seat heaters, seat belt sensor, etc.)

Take a look in the DIY, I did a write-up on adding seat memory. Power for the power S4 Recaors was part of this.

**nimski62** · 12-17-2008 08:36 PM

Originally Posted by derleicaman

Don't understand the question. You have a 3.0 with power seats with no power going to them? Or, do you have manual seats and want to run power? There are 4 sockets below the seat in the floor which control different things (power seats, seat memory, airbags, seat heaters, seat belt sensor, etc.)

Take a look in the DIY, I did a write-up on adding seat memory. Power for the power S4 Recaors was part of this.

No I have power seats, but the seat stopped working.. and i cant figure out why the thick positive cable feeding the seat isnt turning on, and there is no fuse for this either. Passenger side works just fine. Im talking about the red connector.. it has a thick brown wire and a thick red wire along with alot of thin other wires. the thick red one has no power anymore for some damn reason.. the passengers side does. no clue why.

**derleicaman** · 12-18-2008 12:02 AM

There is a seperate fuse for each seat. I believe it is a 30A fuse. They are located in the outer lower corners of the footwells behind the plastic trim panels. I believe you can locate them in the Bentley manual.