Urgent! cant pass inspection

[s4Xcelence13]

Went to inspection, and ran these code p1606 which is ABS(I just dont know where the module is located at) and p1426 which is open valve tank.

And none of the four banks were ready at all. Im running everything below except the awe-twin one which i took off, for now its the ssac. My post-o2 sensors are connected but not in the exhaust(they are near my engine bay) and that throws the code for MAF i believe.

My Vag-Com cannot communicate with the ECU but the inspection stations can... anyone this is very important to me to get this back on the road

[s4Xcelence13]

anyone? please this is important

[s4Xcelence13]

okay for some reason got VAG-COM to work while the car was completely off, but could only read the engine. Codes are as follows(dont have the full verison);

Readiness 0110 0101
EVAP Valve N80 - Open Circuit

P1426
P0102
P1606
P1113
P1603

HELP

[haus4]

alrite ill see what i can help ya with.

EVAP - im guessing its saying that the valve is stuck open. I would test out the valve and clean out the connector.

ABS - did you get what the code means? I dont know off hand, and it could be the module or a sensor.

O2 sensors - you have to be a little more clear, as to which ones are in and which are out. Also you said post O2 are just hanging there. There going to give you a fault if there not in the pipe or have a fouler on them.

The readiness code is going to take some driving to set after you fix it all.

[s4Xcelence13]

For EVAP where are the Valves located?

ABS normally the code means Faulty Module so im guessing that my ABS shat out, but i read on the forums that sometimes it could be a lot of other things, i do have seized rear calipers and not brake pads on them with spacers on all 4 wheels with replica rs4 rims om them.

As for the o2 sensors, the Pre-o2 sensors for the pre cats are in, but the post ones are completely off the exhaust and are sitting near the battery. I think that this is throwing the p0102 code.

[illaudiill]

hmmmmmmm

[lonestar22]

yeah your gonna want to connect those 02 sensors


wait wait wait did u say your car has no brake pads in the back?

[S4 in_lowplaces]

sounds like it to me

[s4Xcelence13]

no it does, found out why i cant connect to the ECU damn ABS. Only problem is what is this EVAP code now? And anyone know why my brand new MAF is already throwing codes?