Guess this part

**rxrep** · 12-16-2008 08:12 PM

Since many of you know my current project, this should be easy.

Have both headlight housings done with dual projectors. The final fuzor skim coat is drying now and CF overlay will start this weekend.

Just did outer portion of lens trim surrounds, and just got done with initial overlay of this:

No resin is on top yet and I haven't fully matted down the CF cloth. Rough, but once it dries, then I'll trim and apply top coats of resin.
I'm getting excited. Can't wait for LED's to show up.

**AudiA4Turbo22** · 12-16-2008 08:57 PM

killer!

**rxrep** · 12-16-2008 09:00 PM

Originally Posted by AudiA4Turbo22

killer!

Thanks. This one wasn't the greatest on my lines, but most of it isn't seen since it's a turn signal. And there are so many little nooks and crannies that getting the CF to wrap right and get in all the little indentations isn't easy. It will shape up nicely once I start on the top coats of resin.
Luckily the big trim piece that sits inside the clear housing half is flat. That will be easier.

**orangelmo** · 12-16-2008 09:02 PM

Where'd you end up picking up the CF from?

**AudiA4Turbo22** · 12-16-2008 09:03 PM

if u get the design down for the LED's and stuff i'll gladly ship u my Bi-xenons and pay whatevers to get his done!

**rxrep** · 12-16-2008 09:13 PM

Originally Posted by orangelmo

Where'd you end up picking up the CF from?

e to the bay.

Managed to pick up a 36" x 12' piece for... wait for it..... $35. No idea how anyone didn't pick that one up. I was only bidder.
2X2 twill weave in I think 5oz. Not good for structural stuff, but perfect for aesthetics and tight curves.

Got UV ultra clear resin from eBay also. I'm doing my splitter and my grilles as well. Grilles will be a project, but they should turn out nice once done.

**orangelmo** · 12-16-2008 11:12 PM

Originally Posted by rxrep

e to the bay.

Managed to pick up a 36" x 12' piece for... wait for it..... $35. No idea how anyone didn't pick that one up. I was only bidder.
2X2 twill weave in I think 5oz. Not good for structural stuff, but perfect for aesthetics and tight curves.

Got UV ultra clear resin from eBay also. I'm doing my splitter and my grilles as well. Grilles will be a project, but they should turn out nice once done.

Nice find! Can't wait to see this finished project