Car threw 4 CELs yesterday, autozone ran it...

**James** · 11-29-2008 12:56 PM

P2015 - Intake Manifold Runner Position Sensor/Switch Circuit Range/Performance

and

P2008 - Intake Manifold Runner Control Circuit/Open

can anyone help with these? Car is a 2005.5 A4Q 6spd. I read something about an intake flap? Did a google search on these codes and basically came up with nothing..

James

**RedS-line** · 11-29-2008 09:36 PM

sounds like it could be the flapper. if its still under warranty then take it in and let them fix it.

**trexturk** · 11-30-2008 12:48 AM

i had p2004 and p2008 which is the intake runner codes come up on my daily focus. It was a little square piece that sat under the intake manifold. had a couple vacuum lines and elctrical connector on it.

this prolly dont help ya but im sure its some solinoid near the intake manifold that needs looked at

**James** · 11-30-2008 06:39 AM

Originally Posted by RedS-line

sounds like it could be the flapper. if its still under warranty then take it in and let them fix it.

out of warranty by 3k miles.. go figure.. I found a guy who has one of those flapper motors that he is selling but I don't know if that is what I need or not. Anyone with some ideas, please let me know.

trexturk, yeah that doesn't tell me much. The flapper motor is a sensor and motor all in one.

James

**Kschroers1** · 11-30-2008 09:45 AM

Take it to the dealer and get it diag'ed. Don't beat around the bush with engine codes or you'll spend more money than you will want to.

**tdavit** · 11-30-2008 09:48 PM

i think the reflash that came out about half a year ago had something to do with the flapper

**A4 S-Line** · 11-30-2008 10:06 PM

Originally Posted by tdavit

i think the reflash that came out about half a year ago had something to do with the flapper

Yes the flash was 1/2 the fix. If it shows up mechanically in the flapper then they will replace it under warranty. Just had mine done.

**James** · 12-01-2008 06:19 AM

Yes my car has already had the reflash. The stealership wants $97 just to run the stupid CEL and tell me whats wrong. I said hell no to that, brought it over to autozone and they did it for free. So now that I know the codes, obviously they only thing left is to fix/replace whatever the problem is.. I think in this case, its that flapper motor. Like I said, I found a guy who has one for $200... sounds a bit excessive for a motor but apparently its new and the revision B part. Anyone have one that can beat that price?

James

**A4 S-Line** · 12-01-2008 12:52 PM

I think the TSB number is 2016868/2 - if your car is still covered its a dealer fix, although they often want to charge you to scan it. However if its a warranty item the fee should be waived I expect.