Enkei Nt03+M's in 17x9.5

[bryzf1]

Does anyone know if these exist with the 5x112 bolt pattern... I haven't been able to find it anywhere so I am assuming it doesn't. I know that Raderwerks makes those adapters to make other bolt patterns fit, but I'd rather not go that route it I don't have to. Any help would be appreciated... thanks!

[Das General]

Yea I believe they exist. Torque Factory ran that setup on the EuroGTP

[joules]

I think that I read somewhere that Torque Factory had the Nt03's custom drilled--the 9.5 width was not available in a 5x112 bolt pattern...

[zmw]

enkei japan can and will custom drill any wheel for you - expect about a 100/wheel premium over retail pricing - a few guys also have 18x9.5 RPF1s - Most wheel companies will do this as long as they make the OFFSET in that size, custom drilling is no big deal.