Muffler Shop for Custom Exhaust in Denver area?

[Audi Skate Snow]

Anyone know of a good muffler shop to do a custom exhaust setup for my avant?

Jordan I figured you might know of a good place to go. Im just going to do 3inch back to 2.25 split to magnaflow mufflers.

let me know gang...werd!

[CO AVANT]

Go get a baseline dyno done on your car first fvcker

I don't know any places in Denver for exhaust building sorry.

[Audi Skate Snow]

Go get a baseline dyno done on your car first fvcker

I don't know any places in Denver for exhaust building sorry.

ahah, i dont want to pay for a dyno on a bone stock car... ahahahah

how about in ft collins anyhwere to get an exhaust done?

[CO AVANT]

Yeah Kens Muffler on College Ave but it won't be T304 Stainless steel. You should get the dyno done so you know what gains you made over stock and so I have a baseline to go off of myself ;)

[jrock]

I used Bud's Muffler of of Sante Fe just south of colfax

[Audi Skate Snow]

Yeah Kens Muffler on College Ave but it won't be T304 Stainless steel. You should get the dyno done so you know what gains you made over stock and so I have a baseline to go off of myself ;)

ahahah... so you need it for you huh mang.. ahah

tell ya what we can split the cost and we can go do it.

how much you think a custom setup at the kens place is

[CO AVANT]

I bet they could do one for under $500. I'd look around though and see if there is anywhere that can do it with T304 stainless. I'll split the cost with you if you go dyno before the engine drops. I'd prolly dyno my car again on the same day though as I'm sure I'm gonna get higher #'s than last time cause it will be colder out.

[Audi Skate Snow]

I bet they could do one for under $500. I'd look around though and see if there is anywhere that can do it with T304 stainless. I'll split the cost with you if you go dyno before the engine drops. I'd prolly dyno my car again on the same day though as I'm sure I'm gonna get higher #'s than last time cause it will be colder out.

how much for a dyno run?

[Audi Skate Snow]

I used Bud's Muffler of of Sante Fe just south of colfax

what did you get and how much did ya pay? any pics?

[CO AVANT]

how much for a dyno run?

They charge $65 for 3 pulls

[Audi Skate Snow]

They charge $65 for 3 pulls

lets split it and do it this weekend... my car is 100% bone stock.

[CO AVANT]

3pm on Saturday

[LampyB]

i know Randy at Autobahn Premier Service in Denver has a muffler shop he recommends. i thought it was Muffler King, but i really can't remember for sure. always good to go somewhere recommended rather than a random shop...call him up to find out.

[DenverNoob]

i know Randy at Autobahn Premier Service in Denver has a muffler shop he recommends. i thought it was Muffler King, but i really can't remember for sure. always good to go somewhere recommended rather than a random shop...call him up to find out.

one place they use is House of Mufflers on Evans near I-25 in Denver (yellow and blue building). They do great work, reasonably priced.

[Richard]

Collins Muffler in Loveland is pretty good too

[viperdsa]

I wonder if any of these shops could do an exhaust manifold?

[Richard]

colins might be able to

[viperdsa]

hmmmmm....

[Naudi_Mat]

House of Mufflers is a good place. I know several people that work there so I get pretty decent discounts.

[Audi Skate Snow]

House of Mufflers is a good place. I know several people that work there so I get pretty decent discounts.

hook it up!

[LampyB]

what kind of discounts???

[EBG 18T]

one place they use is House of Mufflers on Evans near I-25 in Denver (yellow and blue building). They do great work, reasonably priced.

The guys at House of Mufflers installed my HFC. Good guys and very affordable. They have alot of older hot rods outside.

[KajunAudillac]

Could have the cheapest muffler shop of them all....Your garage :) Of course this is witht he assumption that one has a welder, pipe cutter, pipe bender, time on their hands etc....

[Audi Skate Snow]

Could have the cheapest muffler shop of them all....Your garage :) Of course this is witht he assumption that one has a welder, pipe cutter, pipe bender, time on their hands etc....

to be honest... if someone on here knew how to weld really good, we could do it in my garage. I have a cutter... we can just buy piping for ourselves and also buy "U" bends and then cut them for any turns.

its really not hard at all to make a custom exhaust

[Richard]

I have been looking for some piping at a reasonable rate...havent found anything yet.

[CO AVANT]

to be honest... if someone on here knew how to weld really good, we could do it in my garage. I have a cutter... we can just buy piping for ourselves and also buy "U" bends and then cut them for any turns.

its really not hard at all to make a custom exhaust

Go buy a welder Charlie

[KajunAudillac]

Two of my friends have welders, but like myself we are in the CO Springs area, and they are not fond of people borrowing their "pricier" tools.

[greensto]

I got my customIZED (fabricated) AWE exhaust done at 3Zero3 Motorsports in Wheat Ridge (near Westminster). They did a great job and I'm loving my car.
-Bobby

[Richard]

how much?

[greensto]

Exhaust= $1100, $600=installation of exhaust, fabrication of the downpipe to fit my auto tranny, installation of test pipe, S4 rear valence+installation, REVO stg II upgrade from my stg I. So... basically the same price as coilovers+installation.

[LampyB]

i'd trust 3zero3 with just about anything on my car, but they're almost as expensive as the stealership on labor.

[greensto]

i'd trust 3zero3 with just about anything on my car, but they're almost as expensive as the stealership on labor.

This is true, but I wanted a perfect job for a major installment. The little mods don't need as much precision.

[KajunAudillac]

Exhaust= $1100, $600=installation of exhaust, fabrication of the downpipe to fit my auto tranny, installation of test pipe, S4 rear valence+installation, REVO stg II upgrade from my stg I. So... basically the same price as coilovers+installation.

THAT EXPENSIVE!!! UGH i did my exhaust on my camaro for $280 , and before i wrecked it, brought my truck to muffler masters and did a dual exhaust for $450.

[greensto]

THAT EXPENSIVE!!! UGH i did my exhaust on my camaro for $280 , and before i wrecked it, brought my truck to muffler masters and did a dual exhaust for $450.

I did my exhaust on my 2003 Celica for $60 and paid $300 for the exhaust. German engineering is a different breed than Japanese or American cars