Just trying to think of anything I am missing.

I got some Eibach coil overs that I am going to install (at its highest point for the winter that is around the corner, with the snow on the ground this morning).

Upper control arms all the way around are getting replaced as they never have been at 200,000 km almost.

What else should I have done if anything while I am in there?

Tie rod ends I think I'm going to get them to look at but I am certain they are ~20-30,000 km's old. I got a wheel bearing I think that is getting replaced. Brake pads are new ~ 5,000 km.