Who's running meth on untuned 2+?

[VonPooper]

Thinking about a meth kit to help out my mtm stage 3 tune....anybody running meth with mtm or any other brand ecu?

[ThirdStrike]

even if you dont advance settings/parameters your car will feel stronger. run dual taps on the bi-pipe for iat cooling...or tap near TB for octane increase

[ThePaintballGuy]

I am running it on a GIAC-X tune. I have not advanced timing or anything like that yet but I can feel gains. It pulls stronger and longer now. I ran IAT's before and after installing the kit and it was about 20 degree difference at WOT.

Josh

[PinoyS4]

pulls harder through the higher rpm range

[Ravalous]

I was running meth with my Giac x (ko3) no tune, and was making some decent power.. on DYNOJET I made 329whp, and 382lbs tq, setup was K04's, 5bar fpr, and full 3" pipes with piggies..

[rageman2]

red is no meth/water, blue is with -







This is on GIAC-X, Ko3s, piggies w/2.5in catback, rs4 intercoolers (A6 2.7T though)

[VonPooper]

I am running it on a GIAC-X tune. I have not advanced timing or anything like that yet but I can feel gains. It pulls stronger and longer now. I ran IAT's before and after installing the kit and it was about 20 degree difference at WOT.

Josh

where did you tap in at?

[Ravalous]

I tap one of the Bi-pipe about 6" from the trottle body. how much hp are you making with your stg3 MTM?

[Sleeeper X]

red is no meth/water, blue is with -




This is on GIAC-X, Ko3s, piggies w/2.5in catback, rs4 intercoolers (A6 2.7T though)

God damn RS4 intercoolers SUCK!!!!

[VonPooper]

I tap one of the Bi-pipe about 6" from the trottle body. how much hp are you making with your stg3 MTM?

u talking apr bi pipe? my mtm tune is good for 345hp at the crank with a 5bar fpr...i just added dps and im running 100 oct so it's a little higher now. pulls pretty hard for a 2+

[Ravalous]

are you running the MTM stg3 right now, or stg 2+?

[ThirdStrike]

God damn RS4 intercoolers SUCK!!!!

and those are good temps for rs4 ic's i was seeing 140/150 degrees F with them ..
they really do suck.

[WMi_S4]

are you running the MTM stg3 right now, or stg 2+?

MTM Stage 3 chip is same as GIAC's stage 2 or APR stage 2 chips, just like AMS stage 5 is really Stage 3 chip, confusing i know

[Ravalous]

I just bought a stg3 AMS ECU, I'm hoping for some nice power, any good news with their stg3 chip?