Vast Meth kit Question

[spinny]

Does anyone have a DIY link for this kit?

I'm mostly interested in the controller wiring - just a little confused where the map signal wire needs to be tapped into.

Other then that this kit seems extremely straight forward - can't see it taking more then a few hours to install - and that's taking your time and doing it right.

[JDM EJ1 95]

its straitforward.. on the top of your Tb boot the map sensor is there... there are 3 wires.. the directions from vast tell you what color wire to tap into i forget.. i can go look at mine if needed.. but the directions outline it pretty well

[JDM EJ1 95]

the only thing is.. just dont listen to the driections for any sort of drill bit sizes.. because you will be all confused and probably get it wrong.. bc the directions are wrong.

[spinny]

same spot you'd wire in a TCD?

[pit viper]

It looks to be a re-badged Devil's Own kit & controller, in which case it is pretty straight-forward.
I did some install graphics for DO back in the day on the SRT kits.

[spinny]

Yes thats exactly what the kit is.

[JDM EJ1 95]

im pretty sure its the blue/white wire?

[pit viper]

if there's 2 solid color wires and one with a stripe, I'd say 95% it's the striped one.

:)

[spinny]

It is the blue grey wire (this was confirmed by Mike @ VAST)

[JDM EJ1 95]

blue grey.. blue white... you say tomato i say tomaaaato