Help! Those that have installed SSAC Catback, what clamps did you use for joining the

[2low4snow]

catback together, where the rear section goes into the Mid-Muffler....

Not sure if the system is supposed to come with clamps or not???

Thanks!

[RogueStatus]

it comes with clamps,but they dont fit. some people put a notch in the piping where it would meet so it can close up a little,but when i installed it on a friends car we just grabbed some clamps at an autozone for the time being. they work absolutely fine just look terrible. but its an exhaust,you cant see them unless you get under the car. and obviously for where it meets the DP's use the stock sleeve clamps.

[2low4snow]

Thanks Kyle, I bought some Accuseal clamps in 2.5" but I think they might be a tad big and cannot clamp down on the pipe also because there is no slit in the pipe.....

[RogueStatus]

yeah i think each pipe is 2.25",we might have used two 2 3/8" clamps

[xx_s4quattro_xx]

catback together, where the rear section goes into the Mid-Muffler....

Not sure if the system is supposed to come with clamps or not???

Thanks!

I used my stocks for that part and used there clamps for the down pipe.