gt2560r question

**juansaaA4** · 09-03-2008 05:56 PM

will the gt2560r fit the stockKO3 feeding lines? and will it fit the stock downpipe? if not what should i buy for it to fit properly

**bigbro** · 09-03-2008 05:58 PM

GTRS eliminator FTW!!!!!!!!!

**dirtybrd** · 09-03-2008 06:00 PM

Don't bother. Anything less then a GT28 series is a waste of time, and money.

**A4ringedONE8T** · 09-03-2008 06:01 PM

Where in Tampa are you at? Give me a call tomorrow, 941-378-9064, ask for Shawn. Ill help you out and get you set up with what you need

And to answer your question, no, not even close on the lines, manifold, or DP, or TIP for that matter

**dirtybrd** · 09-03-2008 06:03 PM

There you go!

**mike-2ptzero** · 09-03-2008 06:15 PM

Originally Posted by dirtybrd

Don't bother. Anything less then a GT28 series is a waste of time, and money.

LOL, the GT2560 is a GT28.

If you look up GT2860 on ATP's web site and then look on Garrett's web site, the GT2860 specs on ATP's web site are exactly the same as the GT2560r on Garrett's site.

GT2560R on garrett site
compressor
Ind - 46.5mm
Exd - 60mm
trim - 60
a/r - .60

exhaust
wheel - 53mm
trim - 62
a/r - .64
---------------
ATP site
Turbine
-Wheel: 53mm w/ 62 trim
-Housing: .64 ar
-Maps

Compressor
-Wheel: 60mm w/ 60 trim
-Housing: .60 ar

**juansaaA4** · 09-03-2008 06:18 PM

the gt2560r IS a gt28 and thanks a lot to everyone for the help

**A4ringedONE8T** · 09-03-2008 06:27 PM

Originally Posted by juansaaA4

the gt2560r IS a gt28 and thanks a lot to everyone for the help

lol, If you havent been in a BT 1.8T and not complete set on a 28RS yet and dont mind coming down to Sarasota, we have a 28RS 1.8 TT (stock motor), 3076R 1.8 TT, build bottom, built AEB head w/ cams, and my 3076R 1.8 A4 (built bottom, stock small port head) all at the shop until the weekend . If you want to see the differences between a few different setups Id be happy to give you a ride in all of them.