Audizine - An Automotive Enthusiast Community

Results 1 to 1 of 1
  1. 08-29-2008 09:49 AM #1
    pmoss
    pmoss is offline
    Senior Member Two Rings
    Join Date
    Mar 24 2006
    AZ Member #
    10996
    Location
    pottstown, PA

    Question Cat Cam Gear Help

    Guest-only advertisement. Register or Log In now!
    The gear is not marked with any degreeing increments, just a couple paint marks and a 6 stamped on two of the holes? I would also like to know where I can measure lift at tdc. Looks like I can get an indicator on the center int. valve? Or are people just setting the cam gear to tdc and rolling with it?
    Last edited by pmoss; 08-29-2008 at 03:06 PM. Reason: easier to read
    GT35r, Cat 3653's, 034 manifold, 1000cc injectors, Ctapp tune, 44mm tial wg, 2.0 block with scat rods and JE pistons, stage 3 SPEC S4 clutch with 240 mm SPEC flywheel, full 3" exhaust, coolingmist water meth, etc.
    Reply With Quote Reply With Quote  
« Previous Thread | Next Thread »

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules



    © 2001-2024 Audizine, Audizine.com, and Driverzines.com
    Audizine is an independently owned and operated automotive enthusiast community and news website.
    Audi and the Audi logo(s) are copyright/trademark Audi AG. Audizine is not endorsed by or affiliated with Audi AG.