So its been over a month since I have done any mods so here we go ...

[QuattroRocket]

Next week the car goes to the performance shop for my 034 Density motor mounts and to have my exhaust rehung.

Why rehang the exhaust you ask ?

Because I am booked into the bodyshop the week after as its high time I get this painted & installed ...



Kerscher rear custom molded (seamless) into A4 rear.

And this ...



Kerscher rear CF splitter

Oh and my possibly one of a kind CF trunk trim strip too !

[oregonaudi]

Damn. You are going balls to the wall. Post pics asap, molded will make it a lot better

[QuattroRocket]

I just wish the front was higher without raising the car so I could get a CF splitter on the front to complete the cf all around lower look.

[Maverick]

i smell 20" wheels with that rear! lol

[oregonaudi]

I just wish the front was higher without raising the car so I could get a CF splitter on the front to complete the cf all around lower look.

I know how that goes. You could always wait until you find a good enough deal and go for it. If it get gnarred up, fuck it.

[QuattroRocket]

I know how that goes. You could always wait until you find a good enough deal and go for it. If it get gnarred up, fuck it.

Well I already bottomed out my USP front so its 100% certain that its a matter of time that I would hit a front that stuck out lower and further forward. Hate to waste money.

[oregonaudi]

Hmm. I guess I thought I was low. Perhaps you drive like a mad-man

[QuattroRocket]

With the new AWE setup I am a little tougher on the gas pedal :-)

[darkstar]

its old home!!!

[QuattroRocket]

Sad that its taken me till now to get it done I know :-)

[IronAudi]

I dont know if i like the4 way the exhaust is sitting behind the fendor. Seems like it should be sitting further out or something