Rebar with Innercooler

[vdubstreets]

What do most of you guys do for a rebar with a inner cooler? I figure most of you dont run any rebar at all. I have been for some time but I think i need to do someting about that, something similar to ER's rebar that comes with the kit.

[RED1.8T]

I used the stock rebar when I had my RaceTec

[bwoy1981]

[QUOTE=vdubstreets;2710527]What do most of you guys do for a rebar with a inner cooler? I figure most of you dont run any rebar at all. I have been for some time but I think i need to do someting about that, something similar to ER's rebar that comes with the kit.

Im in your exact same situation, my intercooler is about quarter inch too high, so my rebar is resting on the top of my intercooler when it was in = terrible fit! But last weekend I bought two brackets from Home Depot to drop my intercooler half inch down to give room from my rebar so I could put it back in. Should work!

ER's rebar would work too tho..... do they sell it separately???

[dougyfresh]

mine fits behind my stock rebar and bumper with no cutting

[Papachristou]

my racetec fit without any bumper or rebar fitament issues

[RLB6]

I remember when my ER Comp FMIC looked that good. Anyways, the Racetec and Eurocode FMIC's do not require an cutting/fabrication of the rebar. ER also makes a sport FMIC as well which doesn't require any cutting as well. I hear it's great for K03/4 applications.

[vdubstreets]

I'll have to look further into it, or ill have to get a smaller innercooler which i may.