Wiring help

[TonyD]

I need to get these red and yellow wires through the cabin into the engine bay. Any ideas? The wires are on the passenger side too. I've been working on this stupid thing all day. Help please!

[cruzin210]

i wired my 4 AWG power and ground (for my headunit) through a grommet just to the left of the battery, just got to cut the nipple off and get the wire through. I fed the wire through some foam insulation and only had to make a small hole. Of course I went from the battery IN to the cabin instead of what it looks like your doing. and take the glove box off before you even dream of getting that wire where you want it to go. GL

edit: looks like 12 AWG twisted cable on the floor, what are you up to?

[utripn]

take your glove box completely off and look for a rubber access hole on the firewall....good luck

[AudiA4Turbo22]

if u bring down the scuddle plate the thing under ur steering column like u do for a boost gauge in the back there's a gromet that has seven holes choose one punch a hole take ur driver's side front wheel off and then run it from behind and on the other side there is another gromet stick it through there and wallah!

[TonyD]

Can you take a picture of the area near the battery? Thanks!

[TonyD]

if u bring down the scuddle plate the thing under ur steering column like u do for a boost gauge in the back there's a gromet that has seven holes choose one punch a hole take ur driver's side front wheel off and then run it from behind and on the other side there is another gromet stick it through there and wallah!

I need it on the other side! You should come down to my house and help me haha.

[kwimberly]

Be careful taking off the glove box - I scratched my center console a little bit when I was setting it onto the floorboard. The sharp edge of the box rubbed the plastic of the console.

[AudiA4Turbo22]

address please! lol j/k! try running it near the cabin filter box!

[TonyD]

Ok the glovebox is off! haha now lets see what I do.

[TonyD]

Ok I found that nipple thing (LOL) and took it off. Now how do i get through that foam stuff?

[AudiA4Turbo22]

punch a hole in it lol!

[TonyD]

Theres metal on the other side!

[TonyD]

Anyone? I'm going insane here!

[8520]

Sharpen and straighten a coat hanger and use one of the grommets mentioned. Poke a hole with the hanger, then tape your wires to the coat hanger and pull through from the engine bay side

[TonyD]

I GOT THAT BITCH! I went through the gromet under the air filter instead of the battery one. BOOM BABY

[AudiA4Turbo22]

^^u better take a vid or i'll shoot u!

[TonyD]

LOL this is retarded. It's done I just need to do some wire protection.

[8520]

LOL this is retarded. It's done I just need to do some wire protection.

split loom and zip ties. Do it.

[TonyD]

I'll post a vid up late tonight/early this morning of what I just installed.

[AudiA4Turbo22]

megaphone FTW!

[TonyD]

It's actually a siren and PA system STRAIGHT from a cop car haha. It's pretty sweet. It's really loud too.