...she's got the flu

[audiblack]

Background: Milltek resonated installed, a month ago i had the APR DPs put on. ran fine for a week then the CEL (check engine light) came on.

Problem: car seems to be running fine, but very rich. a strong smell of gas as well.

Solutions:???

REVO ECU flash to map the fuel ratio, o2 sensors installed wrong?? any help is appreciated.
thank you!

[VR2V8]

Well, you've got 2 great solutions listed there to check into.

1) If it's easy for you, obviously check the O2 sensors first. Free

2) You can do a free trial of REVO and see if it corrects your problem. Free

You might want to do more research first though. I was under the impression that REVO was designed to work with just catbacks. Which means it will still work just fine for you, but has no programming compensation for aftermarket downpipes. Since you have a B6, I thought APR does have the compensation for them. I could have the chip companies completely backwards or wrong here, which is why I say do a bit more research before choosing the chip manufacturer.

[ed@mtl]

Roger, just go see Mike at Rombotis Tuning. I'm sure he can solve your issue.

[audiblack]

Yeah thats most probably whats going to happen since he installed them for me. I just dont have time to go with a full time job..

[ed@mtl]

They're open on Saturdays but they close early, 2pm or so.

[audiblack]

ohh boy. the check engine light is flashing now. the engine seems to be stuttering when reving the engine. sounds kind of funny as well.

what could be the problem?

im fearing a blown coil pack or one of the apr dp's cat converter could be shot?

[<-JOEM->]

ohh boy. the check engine light is flashing now. the engine seems to be stuttering when reving the engine. sounds kind of funny as well.

what could be the problem?

im fearing a blown coil pack or one of the apr dp's cat converter could be shot?

check MAF.

[audiblack]

WHAT DOES ALL THIS MEAN!!!>>?!?!?!


Address 01: Engine

Controller: 8E0 910 560 G
Component: 4.2L V8/5V G 0010
Coding: 0007711
Shop #: WSC 94816

16805 - Warm Up Catalyst; Bank 1: Efficiency Below Threshold
P0421 - 001 - Upper Limit Exceeded - Intermittent

16691 - Cylinder 7: Misfire Detected
P0307 - 001 - Upper Limit Exceeded

-------------------------------------------------------------------------------

Address 03: ABS Brakes

Controller: 8E0 614 517 Q
Component: ABS/ESP allrad 4533
Coding: 04595
Shop #: WSC 06435

1 Fault Found:

01826 - Sensor for Steering Angle (G85); Supply Voltage Terminal 30
35-10 - - - Intermittent

[Shonobi]

16805 - Warm Up Catalyst; Bank 1: Efficiency Below Threshold
This one is probably the a BAD CAT.....I had this with my Milltek DP.