problem with new vogtland/koni install?

[danoe]

Hello all,

I just installed the vogtland/koni combo from PureMS on my 2001 A4 2.8Q, and I'm concerned, as it doesnt seem like its sitting right. The rear of the car is sitting a good 1/2" lower than the front. I did install this myself, so I'm sure there might be something I overlooked, but the install was pretty straight forward. Anyone have any ideas why it looks like this? I was hoping the front might settle a bit, but this picture was taken a week after install.



I realize that isnt the greatest picture, so here is a closeup of the front and back.

Front:


Back:


I'd appreciate any input as its starting to bother me, the pictures I have seen of this same suspension setup have looked very even front to back, and mine does not at all!


-Dan

[jeremy@matrix]

Mike@Pure, you around???

[Mike@PureMS]

Do you have a better picture or measurements on a level surface?
Anything in the trunk? Can you take a close up photo of the front spring installation and the rear spring installation?