MBC/TCD Install?

[RogueStatus]

Bought an MBC and TCD from VAST and had a few questions with the install:

-I'm running GIAC software,so I know I run the MBC standalone. I can't seem to find any write-ups or pictures of one installed standalone,only in parallel with the N75. Anyone have a write-up or pictures of a MBC installed alone?

-When installing the TCD,I don't really want to run it to the MAP sensor wires on the TBB,I've heard theres a way to run it closer to the ECU,anyone have pictures or write-up on that too?

Thanks.

[The_Jerbel]

Just plug the sideways barb into the line coming off of the driver's side of the N75, and the bottom into the bottom.

Nope, sorry. Just skin the wires on the MAP sensor connector and wrap the TCD wires around them.

[YBLEGL]

If you go on www.vastperformance.com they have a diagram of the boost controller. Dont forget if you dont forget if u throw the n75 valve away to put a bolt in the pcv hose and a clamp, or you can leave the n75 plugged in but i threw it away.

[The_Jerbel]

Just leave the N75 plugged in electrically and leave the pass side air line hooked up to it as well.

[RogueStatus]

cool. so you can only wire the TCD to the MAP sensor on the TBB? i'm scared,those wires are thiiiiiiiin hahah

[The_Jerbel]

AFAIK. No worries, it's easy to do. If you break them they're easy to splice.