Took some pics of the finished front moun

[joemomma]

What you guys think?? To bad i cant get the best out of it with this shitty clutch but the clutch masters special setup is in the mail so we shall see. soon

[eliTTe]

one of the better looking installs. good job!

[Matt@JHM]

Looks awesome man. Good job

[BigChris]

thats badass...

[Das General]

Nice work Ricky


Clean install

[McKennaS4]

looks great man! one quick question... i just installed mine and bumper is going on tomorrow!... so i notic from the front view that it is just about a cm off-center. is that the camera angle or is it actually just sliiiightly off? im just owndering if maybe it is centered on the radiator and just slightly offcenter looking with bumer mounted... also did you cut your bumper supprt or delete it completely? if you cut, how much? lastly, was there any cutting of the bumper itself other than removing the grilles? thanks bud. and again looks great! i hope mine looks like that with the bumper on.

[McKennaS4]

oh also! any problems with blowing pipes off under boost with those worm style clamps??

[Das General]

Frankie, use hairspray before you bolt the clamps down.

[joemomma]

looks great man! one quick question... i just installed mine and bumper is going on tomorrow!... so i notic from the front view that it is just about a cm off-center. is that the camera angle or is it actually just sliiiightly off? im just owndering if maybe it is centered on the radiator and just slightly offcenter looking with bumer mounted... also did you cut your bumper supprt or delete it completely? if you cut, how much? lastly, was there any cutting of the bumper itself other than removing the grilles? thanks bud. and again looks great! i hope mine looks like that with the bumper on.

Ya i noticed it to its because of the brackets and camera angle. im eventually going to redo it because im OCD about stuff like that haha. As far as the bumper support i cut EXACTLY like this bumper

As far as cuttin the bumper i just had to slightly cut into the lower right and lower left corners of the center grill because of the couplers. Other than that no cutting to the bumper i think if i got it a little closer to the radiator and up a little higher i would of had to do that.

[joemomma]

oh also! any problems with blowing pipes off under boost with those worm style clamps??

So far i havent been able to get on it because of this damn clutch slipping bad. Ill know in a couple weeks though fo shaaoo. When i get on it in first the only gear that doesnt slip no problems yet. I just tightened them really tight when a socket wrench. Im gonna switch to T clamps for safety racings though. Hope everything goes well for ya!!

[lrg8683]

where'd you get your pipes from?

[McKennaS4]

wow thanks for that pic! i get my bumper tomorrow and ill try to throw it on before paint to make sure my IC is ined up right. appreciate the help bro and deb thanks for the hairspray tip.. i hears that before but i didnt do it so i guess ill do that as a precautionary measure. ill throw pics of mine up when i get the bumper painted and on but here's how she sits now...
wish me luck haha.

[Das General]

visually yours looks pretty good, and i doubt you will have any alignment issues. Mine was straight on as well, al though for some reason it looks off centered in this picture.

[AudiSportB5S4]

yeah i would like to know where the pipes came from as well. im looking into this within the next 2 weeks or so to get it on!