Bluetooth/DNS mic wires

[evilb]

All,

When installing an aftermarket stereo while keeping the RNS-E, is there a way to disable the Dynamic Noise Compensation (which I'm told is done by simply unplugging/cutting the Microphone wire), while keeping Bluetooth functionality?

I suppose my question is are there 2 leads coming from the microphone, or is it just one? If just one, I suppose it's impossible to keep Bluetooth functionality while at the same time disabling DNS.

Please let me know if you have any input!

Thanks,
Brad

[AudiA4b6US]

I have never seen the new dual BT/Bose microphones but in the B6 you could not disable the Audio Pilot by just disconnecting the Bose mic. A wiring change had to be made at the Bose amp and the head unit had to be recoded to disable the Audio Pilot.

[evilb]

Anybody?

I looked at the RNS-E wiring diagram and it only has a single MIC-OUT, so it looks like if I disable DNC it will also mean eliminating bluetooth.

Not a big deal to me because hearing the phone ring through my aftermarket stereo at almost full volume would most likely just piss me off.

[AudiA4b6US]

The Bose mic is connected to the Bose amp, not the head unit.