cupra R splitter install on b7 sline

[Awulf]

Really its not that bad guys I put mine in ten minutes. If you pressed for time just use screws, and trim the center pieces. If it sags later than worry about it then, don't even bother sanding or cutting it may not be as perfect as these examples but 99% will not even notice, just screw it.

[jsocar1986]

Really its not that bad guys I put mine in ten minutes. If you pressed for time just use screws, and trim the center pieces. If it sags later than worry about it then, don't even bother sanding or cutting it may not be as perfect as these examples but 99% will not even notice, just screw it.

I'm already seeing a flame coming up about this question but, I have no idea as to what you guys are referring to in the underlined statement above. Trim what pieces? This means if I want a lip I have to cut the bumper? I cant just screw it in and be done with it? Also, I have a non-S-line bumper cause I "thpethial" cause my momma said so.

[OpenSkye]

I'm already seeing a flame coming up about this question but, I have no idea as to what you guys are referring to in the underlined statement above. Trim what pieces? This means if I want a lip I have to cut the bumper? I cant just screw it in and be done with it? Also, I have a non-S-line bumper cause I "thpethial" cause my momma said so.

no, dont trim the bumper.

trim the mounting tabs in the center of the lip (on top).

[marty was here]

no, dont trim the bumper.

trim the mounting tabs in the center of the lip (on top).

good advice, but its coming from an a3 owner, so take it with a few grains of kosher salt

[OpenSkye]

good advice, but its coming from an a3 owner, so take it with a few grains of kosher salt

yeah, u would think i've seen one or sumthin right?


and those b7 bumpers, oh boy, so complex.

[marty was here]

yeah, u would think i've seen one or sumthin right?


and those b7 bumpers, oh boy, so complex.

=

sush u

[The Broker]

Where can I buy this lip? How does it look with no side skirts?