how do you.........................

[elgallo]

how do you remove the foglight housings to replace the lightbulbs? anybody?

[nadroj81]

remove the grills. then there are like 2 bolts you have to undo. its a Torx screw.

[Tim0s002]

Im not too sure if I am qualified to answer this, but i was watching when someone did it for my car and he just pulled out the foglight grill (it looks like it just comes off pretty easy) and then use a screw driver to take out the bulb. It looked pretty easy, not sure why no one else responed cause i seen this question earlier today.

I hope this helps.

*edit*
Yeah, i forgot it was a torx screw

[yoogene83]

you need to remove the foglight grills before anything. look at it straight on, you'll see four tabs, two on top and two on the bottom.

get a flathead screwdriver and pull the ones on top down and pull a little at the same time to get it out of the tabs. pull the bottom ones up and pull the grill out.

get a torx screwdriver and unscrew the two bolts holding the foglight housing in place.

then pull out the bulbs and replace as neccesary

just push the grill back in place and it should snap back in without a problem...unless you broke a tab

[CO AVANT]

You can get those little wierd German star looking bits @ Home Depot...

[Audijay02]

You don't even have to remove the housing to get into the light bulb, first off remove the foglight grills, then reach your hand inside the back of the housing and twist off the bulb holder and pull it out and then disconnect the plug, took me about 15 mins on the first bulb and 5mins on the other one since i know what to do from there. Hope this helps