Kufatec Help?

[Quattro4mage]

Pyrobecks,

I cut the pins off the Kufatec harness and spliced into the existing pin 16 and 18 conductors. No need to remove them from the harness. See note 8 of my original write-up. They basically run to the high beam bulbs in your existing halogen housings.

To help you confirm the correct pins:

Pin 16 = white/yellow wire
Pin 18 = white/black wire


When coded for halogen lighting pins 16 and 18 are routed to the high beam bulbs. When coded for xenon pins 16 and 18 are routed to DRl bulbs. The DRl bulbs in the xenon housings are actually in the same location as the high beam bulbs in the halogen housings. The only difference is the wattage and how they are switched.

Hope this helps.

[pyrobecks]

I thought the pink wires were for the DRL's.... but anyway when you spliced the wires did you cut them or leave the existing wires still attached?

TIA