colorado based machine shop

[UlyssesS4]

long story short, i had my B5 S4 2.7L BEL block bored and honed by Area machine, installed 82.5 MM JE pistons and IE H beam rods and now I have low compression and leak down tests on cyl 5 is over 20% so contemplating going back to a stock block, BEL/BF preferred and having the stock pistons re-ringed etc and putting in Rods ( running TTE600's on 26lbs boost) and need to find a machine shop who can do all this work and assemble the block, as well as having my current 2.8 heads gone thru as well.

Any recommendations on who can do this work in the denver area ??

Area machine doesn't do assembly of the block, Rev Motorsports, MadCap only doing domestic work. I called AMS in fort collins and they said they can do the work but don't know much about them. I called DC Engines but haven;t heard back from them.

[UlyssesS4]

I think I might have settled on one particular shop, feel very good about this one. Most of the metro machine shops won;t do assembly and or work on non domestics platforms, a few of the long time shops with good reps are now closed