Diy single trubo s8 build

[Chase z]

Building a single turbo manifold for my s8 plus
With a pulsar g40 1150 knock off turbo.

[Chase z]

Got the passenger side manifold piping to the t4 flange mocked and tacked in place.

[Chase z]

Got the drivers side bank mocked and tacked into place

[jbain2]

Interesting. What prompted you to go the single route?


Sent from my iPhone using Audizine Forum

[Chase z]

Interesting. What prompted you to go the single route?


Sent from my iPhone using Audizine Forum

i am kinda a power junkie and with a single there are upgrade paths to swap in a bigger turbo if wanted, With twins u are kinda limited. Plus I wasn't spending 6k for some srm1000 turbos. I allso enjoy making sh*t

[Chase z]

A picture of my built 2jz 350z I did a few years back and have updated a few times since then. This is how it sits now.

[jbain2]

A picture of my built 2jz 350z I did a few years back and have updated a few times since then. This is how it sits now.

Looks like a good size turbo on that thing…


Sent from my iPhone using Audizine Forum

[Chase z]

Its only a bw s476sxe so it's size is vary deceiving. It has the same power potential as the g40 copy I'm putting on the s8, but I think this winter I will probably swap a g42 1250 or 1450 onto it. The car is very traction limited tell about 4th gear depending on the surface.

[Chase z]

I got the manifold most likely welded up . I welded most of it other then the bottom section where the bellows is to account for shrinkage, going to knock out the bottom section tomorrow, it was all backpurged ofcourse.

[Chase z]

It

[Chase z]

Got the gates added and the hole mainfolds welded up and drop 0ff at jet hot to get there 2k coating. Also got a temporary turbo to throttle body adapter madeup while I 3d scan and design a new one with a alphaloc clamp instead of the ugly silicone coupler.

[Chase z]

Made a tb to turbo intake on fusion 360 then printed it in pla for a test fit, ordered a aluminum printed set that should be here before the end of the month