PDA

View Full Version : Wheelbearing or CV joint or neither?



VtAudi
10-13-2006, 05:23 PM
So I had some cliking a while back, (front right) So I replaced my whole front right cv assembly, joints and shaft.... Cliking still there, was kind of hard to duplicate UNTIL today!!!
If I crank the wheel left (probably the same w/ right) and drive in circles I get a clik.... clik.... clik, border line clunk.....
Could that be my wheel bearing? Fronts have 160k on them, so.... w/ the new cv assembly I would think that rules that out, anyone have something similar?

TIA

offroader1006
10-14-2006, 11:20 AM
whered you get the axle from?

ive seen many new/bad axles

AudiMV
10-14-2006, 11:31 AM
i replaced my cv joint and 5,000 miles later it tore...i ended up replacing both my axles with raxles...so i could be your cv boot again....check for gross ass grease in the wheel well

VtAudi
10-14-2006, 03:58 PM
CV assembly came from the dealer, so I think I'm going to bring it back to them and have them check it out, I'm thinking it may be my driver side? Though the noise is from the right.......