PDA

View Full Version : Tre



TQMB5
10-13-2006, 03:01 PM
I can not get my TRE's out of the housing, do i need to align that groove any certain way or should it just pop out? i have a ball joint seperator kit but it still wont budge. Im More then feed up with this CA, TRE and coilover install so any help would be useful

Neo1130
10-13-2006, 04:47 PM
What you have to do is get a special tool or a screw driver you don't care about, and hammer it into the little slot on the side, then you put the bolt in back up top and hammer that down a bit... Work the bolt out more and hammer a little more... Do this until you can get the TRE out of the knuckle...

Wholsea
10-14-2006, 05:39 AM
So, you took out the pinch bolt right?

Removed the 8mm bolt from the top (I think its 8, if not, its a 10mm) and tried to pound down on the TRE to bang it out?

The only part I've ever had a problem with was the pinch bolt, I've had to drill them out before...

TQMB5
10-14-2006, 09:10 AM
wait what pinch bolt? i think that was suppost to stay in there, that could be my problem