MyDimeIsUp
05-23-2023, 09:32 PM
Hey all,
As I'm sure some may have seen my last thread, got in a very small fender bender due to bad brakes installed by previous owner and heavily worn rotors. I have Zimmermann rotors and Akebono pads on their way and should be arriving by the end of this week. While doing a scan for my A/C not working (Looks like faulty pressure switch which has been failing since early this month) I noticed that Module 53 (Parking Brake) has "C1011 00 - Brake pad replacement mode active (Status: Intermittent)". I cycled the parking brake on and off, then tried using the default OBDeleven app to enable and disable brake pad replacement mode but it would fail. I then tried going to Module 53, Basic Settings, then "End lining change mode" but would get the error "Function unavailable". I also get the same for "Start lining change mode". It looks like the Parking Brake module is stuck in lining change mode.
Parking brake works just fine on both side and I have 0 dashboard lights nor any other associated codes in other modules relating to parking brake. Anyone have suggestions on why this is happening? I want to get this figured out before the pads and rotors show up at my door.
As I'm sure some may have seen my last thread, got in a very small fender bender due to bad brakes installed by previous owner and heavily worn rotors. I have Zimmermann rotors and Akebono pads on their way and should be arriving by the end of this week. While doing a scan for my A/C not working (Looks like faulty pressure switch which has been failing since early this month) I noticed that Module 53 (Parking Brake) has "C1011 00 - Brake pad replacement mode active (Status: Intermittent)". I cycled the parking brake on and off, then tried using the default OBDeleven app to enable and disable brake pad replacement mode but it would fail. I then tried going to Module 53, Basic Settings, then "End lining change mode" but would get the error "Function unavailable". I also get the same for "Start lining change mode". It looks like the Parking Brake module is stuck in lining change mode.
Parking brake works just fine on both side and I have 0 dashboard lights nor any other associated codes in other modules relating to parking brake. Anyone have suggestions on why this is happening? I want to get this figured out before the pads and rotors show up at my door.