PDA

View Full Version : How do i remove projectors from housings?



streamline
03-31-2006, 05:02 PM
unscrewed the 3 screws and removed the clips but it is still too big to be pulled through back of housing????

offroader1006
03-31-2006, 05:16 PM
seperate the peices, and it will come out with a little work

streamline
03-31-2006, 05:28 PM
they are seperate and i can't seem to fit it out the rear???

BarryT82
04-01-2006, 02:37 AM
Turn the reflector part 180 degrees and pull it out at an angle, The lens comes right out then. The reflector isn't going to just fall right out. It has to be forced out a little, but pop it out at the bottom side of the housing where it's flat.

diegomatrix
04-01-2006, 03:50 AM
^6 bary knows what he's talking' about...
just separatent hsosing and pull out from where the xenon ballasts got... it'll bej a tightr squeeze..

good luchk

lowestA4
04-01-2006, 05:46 AM
It works....

think about it. You`ll make it! I did that a couple of times before:

http://home.arcor.de/jens21/B5 projector swap 001.jpg

http://home.arcor.de/jens21/B5 projector swap 002.jpg

http://home.arcor.de/jens21/B5 projector swap 003.jpg

http://home.arcor.de/jens21/B5 projector swap 005.jpg