Wheel bearing & Hub Assembly

[dmvinnyfl]

Is there a wheel bearing and hub assembly for AUDI A6 C7 3.0T model? for the life of me I cannot find one to order, so I can DIY (I'd rather not buy a press lol)

[A6sport]

I believe there is, check FCP euro...

[gk1]

For rear axle on FWD models yes.
For AWD no, not that I have seen. They just sell kits that are the bearing and hub but not already fitted together.
Although I am not sure why exactly other than cost. It allows you to reuse the potentially $150-$275 hub and just replace the $80-$290 bearing.

[dmvinnyfl]

For rear axle on FWD models yes.
For AWD no, not that I have seen. They just sell kits that are the bearing and hub but not already fitted together.
Although I am not sure why exactly other than cost. It allows you to reuse the potentially $150-$275 hub and just replace the $80-$290 bearing.

I have noticed Ebay has a couple, not sure the quality, whats involved in pressing the bearing in? can I do it myself?

[gk1]

I have noticed Ebay has a couple, not sure the quality, whats involved in pressing the bearing in? can I do it myself?

I assume you are asking about the quattro, not the FWD?
It's involved, but not impossible obviously. If you are not a DIY type of guy it might be better to leave it to a pro. Maybe check out some YouTube videos to get an idea.
It would be easier with a press, but at least on the quarto you could theoretically get the assembly off and just bring it to a shop to press out and in the new bearing. With the other varieties you have to get the whole upright off to bring it to a shop.
I've done them before on the car (older car) with this tool, but again, not for the faint of heart.

http://www.sirtools.com/B90.htm

[A665]

Check FCP Euro.

For Quattro models (at least), all four corners use the same part.

[jcoleman_11]

Not the assembly. Not from a reputable brand anyways. Gotta get the hub and bearing separate and get them pressed together.


Sent from my iPhone using Tapatalk