Who’s running Aquamist Watermeth system

[Patrick Matte]

Im thinking about WMI, few options but really like the aquamist system. Curious to know who’s running it ? Direct injection with SRM plate’s ? Why you choose that system ?

Thanks all for any information or help !


Envoyé de mon iPhone en utilisant Audizine Forum

[Patrick Matte]

Nobody ! Hummmmmmmm


Envoyé de mon iPhone en utilisant Audizine Forum

[2k16A6]

Nobody ! Hummmmmmmm


Envoyé de mon iPhone en utilisant Audizine Forum

The B8 S4 shares the C7.0’s 3.0T, that forum is much more active and I see quite a few posts about running wmi, I’d bet you will get a response there.

[jmurez]

My RS7 has aquamist running the APR 100 octane program with 93 octane fuel. 100% meth was the best performance for my set up.

[Patrick Matte]

The B8 S4 shares the C7.0’s 3.0T, that forum is much more active and I see quite a few posts about running wmi, I’d bet you will get a response there.

Good idea ! I’ll do that. Thanks :)


Envoyé de mon iPhone en utilisant Audizine Forum

[Patrick Matte]

My RS7 has aquamist running the APR 100 octane program with 93 octane fuel. 100% meth was the best performance for my set up.

Nice ! Where did you install the runners ? It should run great on 100 oct file man, RS7 are killer car !


Envoyé de mon iPhone en utilisant Audizine Forum

[jmurez]

I didn’t do the install, so can’t say specifically how the lines were run. I do know the 1.0mm jets were used on each RocEuro intake tube. Map sensor wire hooked up to the map sensor on the drivers side, pre-intercooler, near the throttle body. Stock settings used on the Aquamist controller.

[jmurez]

Also control box is in the glove box and gauge is in a pod in the passenger side cup holder. 2.5 gallon tank in trunk area. I don’t have to refill nearly as often as I thought I might have to.

[bendsley]

I'm running ProMeth with .8mm nozzles directly into SRM turbo housings on a 2016 S7.
209918