How do I replace the windshield washer hose? [Archive]

saoniel

11-28-2020, 06:18 PM

I have seen posts on this before. Hose is broken in 2 places. Where it goes into the fender and a little closer to the hood. I bought some new hose from ESC. I have tire off and the fender liner off. I can not see how I can get to this hose. Seems like i might have to remove the fender. I saw something about using the old hose to fish the new hose in. I only have access to about 1/2" of the old line. Any thought on how to do this would be helpful.

Steve

deusilan

11-29-2020, 12:18 AM

Remove fender and bumper. Then you should see the line fully. A buddy suggested leaving the fender and just routing the hose up a new way. I will try that the next time I pull the bumper off.

Sent from my SM-G965F using Audizine Forum mobile app (http://r.tapatalk.com/byo?rid=87676)

saoniel

11-29-2020, 07:22 AM

Thanks, that what I was thinking. Re-routing the line may be a possibility that will have to look at after the bumper comes off.

saoniel

12-02-2020, 05:27 PM

Well i did it. Pulled left side of bumper and removed fender. I still had to buy some rubber hose to connect the ECS Tuning hose to the pump and to the y connection in the hood. I took a few pictures and will have to post them. I have working windshield washers! Yea!

Audi-Nooby

12-08-2020, 07:28 PM

Well i did it. Pulled left side of bumper and removed fender. I still had to buy some rubber hose to connect the ECS Tuning hose to the pump and to the y connection in the hood. I took a few pictures and will have to post them. I have working windshield washers! Yea!

I have the same issue so pls post pictures asap.

Sent from my iPad using Audizine (http://r.tapatalk.com/byo?rid=87676)