bruce_miranda
11-13-2020, 09:06 AM
I thought the community might like this. Its a breakout board for the 38 pin connector that is used on several Audi amplifiers.
If you have installed a Zen-V, want to use the amplifier outputs into a summing device or want to by-pass or change the positions of any of your car speakers, you can do so using this and with no cutting or splicing of cables.
Combined with the male plug that goes back into the B&O amplifier, everything is plug and play.
I had made a prototype earlier in the year but I was trying to do too much with it combining it with the 32 pin plug etc and it worked out super expensive. This should be a lot cheaper and you can decide what you need.
Options available are:
1. Bare board only. Easy and cheap to ship.
2. Board + 38 pin connector. Because you prefer soldering your wires to the board.
3. Board + 38 pin connector + terminal blocks, in kit form. Because you are happy soldering and want to have some fun putting this together.
4. Completely assembled product, ready to install in your car.
The plug with the wires is already available on Aliexpress. But if there is demand for this, then I can check if it can be included.
I have deliberately not included an enclosure because various people will want to install this in different ways. But there are mounting holes and also all the terminal blocks are arranged in a way so that all the wires exit only from the one side opposite the large connector.
If you have installed a Zen-V, want to use the amplifier outputs into a summing device or want to by-pass or change the positions of any of your car speakers, you can do so using this and with no cutting or splicing of cables.
Combined with the male plug that goes back into the B&O amplifier, everything is plug and play.
I had made a prototype earlier in the year but I was trying to do too much with it combining it with the 32 pin plug etc and it worked out super expensive. This should be a lot cheaper and you can decide what you need.
Options available are:
1. Bare board only. Easy and cheap to ship.
2. Board + 38 pin connector. Because you prefer soldering your wires to the board.
3. Board + 38 pin connector + terminal blocks, in kit form. Because you are happy soldering and want to have some fun putting this together.
4. Completely assembled product, ready to install in your car.
The plug with the wires is already available on Aliexpress. But if there is demand for this, then I can check if it can be included.
I have deliberately not included an enclosure because various people will want to install this in different ways. But there are mounting holes and also all the terminal blocks are arranged in a way so that all the wires exit only from the one side opposite the large connector.