Can’t recode abs with Vcds lite - HELP!

[RunsDeep]

Hi,

Need some help! Running vcds lite trying to code & then hopefully bleed the abs -following Ross tech procedures to a T but it won’t let me get past the last necessary step, calibrating the steering angle sensor [headbang]

- after Coding & clearing any codes , everytime I login & open 001 to do the calibration it doesn’t let me press “Go!” —- any help would be greatly appreciated -Thanks!

Steering Angle Sensor (G85) Calibration
Before starting the procedure turn the steering wheel at least 30 ° left and back straight ahead.
[Meas. Blocks - 08]
Group 005 Field 1 (Steering Angle Sensor -G85-)
Specification: 0.0 °
Tolerance (when straight): ±5.0 °
[Done, Go Back]
[Login - 11]
Enter 40168
[Do It!]

Group 001
[[B]Go!] <——-*CANT PUSH GO!
[Done, Go Back]

https://oi43.photobucket.com/albums/e376/Dajohnguy/C6E3E9E0-BCBA-4968-86B6-7C34810724D9.jpeg

[jbain2]

The problem you are describing is common with getting stuck where you are. Frankly most people have just gotten lucky and after trying several times the “go” prompt becomes available. I had the same issue. I know this isn’t that helpful but at least you know you’re not alone.


Sent from my iPhone using Tapatalk

[RunsDeep]

The problem you are describing is common with getting stuck where you are. Frankly most people have just gotten lucky and after trying several times the “go” prompt becomes available. I had the same issue. I know this isn’t that helpful but at least you know you’re not alone.


Sent from my iPhone using Tapatalk

Thanks for the reply!
I did read someone say they got lucky on the 3rd try lol ...I don’t know what else to do ... I must’ve tried it 50 times by now ...