New key matching

[climb4hope]

I know this topic was brought up in the forums a lot, but I'm still looking for help. I need to match the immobilizer of the new key bought on ebay. I have only one key and want to add a backup key. Unfortunately I don't have the SCK pin and that is what is stopping me. It seems like the solutions end up with VAG tacho or VAG commander. I have a genuine HEX-CAN from Ross-Tech. Can it work with one of the tools above that can reed eeprom?
I have a bunch of other cables (Chinese clones for other cars INPA D-CAN cable, toyota k-line cable, etc...), but none of them seems to work with these tools.

Does anyone have a working setup in the Seattle area?

Or any there any other ways to get SCK pin with different tools?

[rollerton]

I got you covered. I have a Gdrive with what you need in it. Runs right through your Hex-Can cable. Turn off 'Boot in Intelligent mode' and use VagCommander to read the SKC.
Here's the DIY: https://sites.google.com/site/imnuts/

I'd send you the Gdrive link but looks like I can't access Google type accounts here at work. But if you need it, I have it.

[climb4hope]

I got you covered. I have a Gdrive with what you need in it. Runs right through your Hex-Can cable. Turn off 'Boot in Intelligent mode' and use VagCommander to read the SKC.
Here's the DIY: https://sites.google.com/site/imnuts/

I'd send you the Gdrive link but looks like I can't access Google type accounts here at work. But if you need it, I have it.

I would definitely love to get a link for VagCommander 2.5. Can you PM me a link once you get a chance? Thanks a lot.
I ordered a Chinese Cable since I have HEX-V2 rather than HEX-CAN and V2 can not be put into "dumb" mode. They removed FTDI chip from it. But hopefully should be able to use it with the chinese cable.