PDA

View Full Version : Will these injectors fit?



BranCKY3
12-18-2005, 04:20 PM
http://www.vastperformance.com/images/bosch_36lb_inj.JPG

Bosch 36# injectors at 3 bar(378cc/min)

Anything else needed to run them on a stock fuel rail?

k0mpresd
12-18-2005, 06:16 PM
are those high impedence or low impedence?

and also, you will need some sort of fuel rail spacer

BranCKY3
12-18-2005, 08:32 PM
I dunno about the impedence, it doesn't say anything about it on the site. About how much are spacers, like $20? The injectors are $160 shipped for all 8, I was planning to buy them and split the cost with 01'A41.8T for use with our new K04 chips coming out soon.

k0mpresd
12-18-2005, 08:40 PM
you need to make sure they are high impedence...low impedence will NOT work and youll end up w/ more problems than you want (fried ECU or youll have to wire in resistors on all 4 cyl's)

spacers can easily be had for free if you look around your garage for some washers long enough [:)] ...if not that then ecstuning sells a spacer kit or the washers that are used on the exhaust manifold work really well too

BranCKY3
12-18-2005, 09:55 PM
Yea they are high impedence. Now I just need some money so I can pick them up, that is, if they'll work in the chip setup.

goldenchild
12-19-2005, 06:52 AM
those look longer than the ford 42lbers

k0mpresd
12-19-2005, 07:30 AM
they look like a normal bosch style injector...which is what green tops are as well

if they are high impedence they will work and you will need fuel rail spacers