Front Brake Pins Torque setting???

[db12]

Anyone happen to know the recommended Torque setting for the 2 front brake caliper pins? (not the front caliper carrier bolts). Thanks!

[cspcrx]

about 25ft lbs if I remember right. It is posted on here, do a search for brake DIY. Those are the specs I used. Sorry do not recall the exact number.

[sacandagaD]

Anyone happen to know the recommended Torque setting for the 2 front brake caliper pins? (not the front caliper carrier bolts). Thanks!

This was in the DIY brake write-up started by Mr. Shickadance a while back:

Fastener Tightening Specifications

Brake Pedal Bracket to Body Nut - 8 nm
Brake Pedal Mounting Pin to Bracket Bolt - 8 nm
Electromechanical Parking Brake Control Module Nut - 3 nm
Electromechanical Parking Brake Motor to Rear Brake Caliper Bolt - 12 nm
Front Brake Caliper to Brake Carrier Bolt - 30 nm
Front Brake Carrier to Wheel Bearing Housing Bolt 1 - 196 nm
Front Brake Line Connection to Brake Caliper - 20 nm
Front Brake Pad Bolt - 5 nm
Front Cover Plate Bolt - 10 nm
Gas Pedal Module to Brake Pedal Bracket Bolt - 8 nm
Rear Brake Caliper to Brake Carrier Bolt 1 - 35 nm
Rear Brake Carrier to Wheel Bearing Housing Bolt - 100 nm + 90 degrees
Rear Brake Hose in Brake Caliper - 19 nm
Rear Brake Hose to Brake Pipe Line - 12 nm
Rear Brake Pad Bolt - 5 nm

[weaselp1]

Here you go

http://i187.photobucket.com/albums/x129/weaselp1/Front%20Brake%20s4_zpskbrszlob.png (http://s187.photobucket.com/user/weaselp1/media/Front%20Brake%20s4_zpskbrszlob.png.html)

[cspcrx]

Close 22ft lbs.