View Full Version : Torx Bolt Size center Cross Brace S6
IceyTys
04-12-2016, 11:57 AM
Hey all, so I am working on my exhaust this weekend and want to remove the cross brace under the resonator, but its in place by 4 larger torx bolts. Does anyone know what size torx bolt those are under there? I need to purchase a socket drive bit, but wanted to find out the size in advance.
Tried looking it up and no luck.
Im sure some of you that have done a DIY Exhaust swap may already know.
Thanks
MadAboutCars
04-12-2016, 05:10 PM
They're most likely a triple square bolt. I don't know the size, but if you're going to do more work on your car it would pay to buy a set, something like this:
http://www.ebay.com/itm/Long-Spline-Bit-Socket-Set-Triple-Square-1cm-Drive-4mm-10mm-BERGEN-AT647-/401045198544?hash=item5d602816d0
turbello18
04-12-2016, 05:15 PM
http://uploads.tapatalk-cdn.com/20160412/2fb4878aa774477545aa2fef532f6e3b.jpg
Just checked. It's a 10 mm triple square.
Sent from my iPhone using Audizine mobile app
IceyTys
04-13-2016, 06:53 AM
http://uploads.tapatalk-cdn.com/20160412/2fb4878aa774477545aa2fef532f6e3b.jpg
Just checked. It's a 10 mm triple square.
Sent from my iPhone using Audizine mobile app
Youre the man....thanks for doing that!!! [hail]
turbello18
04-13-2016, 06:23 PM
NP and good luck. I had to use washers on the underside of this bracket to bring it down a bit and prevent the milltek from rubbing. Maybe that will help too.
Sent from my iPhone using Audizine mobile app
IceyTys
04-14-2016, 12:12 PM
NP and good luck. I had to use washers on the underside of this bracket to bring it down a bit and prevent the milltek from rubbing. Maybe that will help too.
Sent from my iPhone using Audizine mobile app
Good to know....I've already installed my exhaust, but I am getting some vibration when braking (only) down from 20mph, so something is definitely rubbing, so I'll look for that as well.