PDA

View Full Version : pilot bearing question help.



ccollick13
01-22-2015, 10:49 AM
is the pilot bearing deep enough. it feels lined up with the house but in the pick it looks right. i know I'm around the 1.5mm mark. how big of a deal is it if its not perfect or well it fix it self if its short a little bit
http://www.facebook.com/photo.php?fbid=10206018169998395&set=gm.768074963300771&type=1&theater

redline380
01-22-2015, 10:54 AM
I'm pretty sure it cannot be driven in too far. If it is sticking out a little, it will be difficult to mount the engine until it slides in far enough

ccollick13
01-22-2015, 11:01 AM
thanks i should be good then since its docent want to move an more

BaseDrifter
01-22-2015, 11:07 AM
When I put a new pilot bearing in a pressed it in just to the edge of the chamfer on the crank, same depth as the original one I pulled out. No problems with it.

http://i346.photobucket.com/albums/p439/blkA4alb-3/Chris%20B5/DSC07909_zpsade1795b.jpg

walky_talky20
01-22-2015, 12:59 PM
Yep. Edge of chamfer.