PDA

View Full Version : Caliper Wind Back Issue



BikerBill
11-01-2014, 11:31 AM
I'm replacing the rear pads on my 2000 A4 Quattro. I have a caliper wind back tool with a bunch of adapter plates. The pads on this caliper were really worn down so the piston is extended quite far. My wind back tool does not fit into the caliper jaw. I can rotate the piston but it does not wind back in. Any tricks I can use to get the piston to retract?

JaysA4
11-01-2014, 11:38 AM
Push reaaaally hard. Your kit should have an attachment for a 3/8 drive, pop that on and put some pressure on it.