PDA

View Full Version : Suspension: Bilstein + H&R



CANaudi
08-06-2013, 01:55 PM
I just recently picked up a set of Bilstein shocks and H&R springs. I wasn't planning on buying them, but the price was unbelievably cheap. So, that being said, I am wondering if I will have any issues with rubbing or fitment before I attempt installing them?

They will be going on a 2001 A4 B5 1.8T. My current tire/wheel combo is:

R8 replica wheels (I believe the offset is ET35 but I can confirm this later this evening)
Tire size is 235/40/18

Has anyone else run a similar setup and potentially have a picture to reference? Will I need spacers (and if so, what mm)? Is it necessary to roll the fenders or modify the wheel liner?

Thanks

TJN0923
08-06-2013, 02:17 PM
Springs don't go low enough to roll fenders, rub the tires, or have fitment issues.

It'll give you a nice drop, but you'll still have anywhere from a 1-2 finger gap the whole way around.

MooseWhip
08-06-2013, 02:29 PM
I'm on h&r race springs and had to pull my rear quarters a bit do to rubbing on dips. I'm on 17x8 et15 in the rear

CANaudi
08-06-2013, 09:03 PM
Thanks for the replies. I should also note that the H&R springs are the Race version.