PDA

View Full Version : GT2871R wastegate actuator



ToXicXxX
07-27-2013, 10:15 PM
So I was getting frustrated at the fitment of the actuator around the intake housing... I ended up cutting the bolts down and bending the stem a bit. I just need to know if it's ok that I turned the stem and bent it a bit (actuating it by hand yields the flapper moving). I am also a bit concerned that I had to pull it a bit forward to fit it, and I'm wondering if this will effect the actuation PSI?

Picture of my setup:

http://i.imgur.com/dsSsHhz.jpg

Sorry for all the threads, seems like nothing can go right.