CKim
06-03-2013, 06:07 AM
Hello,
My car's Steering gear box (J500) has been replaced with new part and trying to basic setting by "learning end stop" with VAS tool.
First, we performed basic setting in G85 and could be suceeded.
Afterward, we did "learning end stop".
In instruction, acoustic sound should be hearible at the end stop position.
But in my case, there's no sound at all and steering angle value is always '0'.
And I compared 2 measured value "Steering wheel angle" and "Steering angle".
The problem is "Steering angle" was always "0" even turning the steering wheel.
On the other hands, "Steering wheel angle" value was changed by turning the steering wheel.
Does anybody knows what's the differences between "Steering wheel angle" and "Steering angle"?
Why "Steering wheel angle" always "0"?
My car's Steering gear box (J500) has been replaced with new part and trying to basic setting by "learning end stop" with VAS tool.
First, we performed basic setting in G85 and could be suceeded.
Afterward, we did "learning end stop".
In instruction, acoustic sound should be hearible at the end stop position.
But in my case, there's no sound at all and steering angle value is always '0'.
And I compared 2 measured value "Steering wheel angle" and "Steering angle".
The problem is "Steering angle" was always "0" even turning the steering wheel.
On the other hands, "Steering wheel angle" value was changed by turning the steering wheel.
Does anybody knows what's the differences between "Steering wheel angle" and "Steering angle"?
Why "Steering wheel angle" always "0"?