P3 GAUGE installed, slight issue

[ENV²]

I installed my P3 gauge yesterday and removed my AWE boost gauge (thanks for the phone support RichiB!) and everything is good to go. The one problem I am having is when I set my boost sensor to the analog tap it's reading very incorrect. Under heavy boost its reading -99 -97 which is heavy vacuum and no boost it never goes into the positive. In the digital boost mode (reads off OBD port) it shows +10-12 under WOT.

I put the tap into the hose I used for my AWE tap. I had no problem with the AWE gauge with this hose and its location.

Am I missing some kind of calibration step?

[ENV²]

nobody? Everyone had no problems with their analog tap?

Maybe my tap itself is defective

[Blackhawk878]

Did you do the analog sensor calibration? Mine did that at first too until I calibrated it. Go here: http://www.p3cars.com/vag-install/ towards the bottom of the page tells you how to calibrate for ambient conditions. (Cal.B)

[socfan12]

While you're in the config menu, you may want to set the engine type correctly, otherwise some other metric comes up incorrect, too (may affect boost, but don't think so).

[ENV²]

Did you do the analog sensor calibration? Mine did that at first too until I calibrated it. Go here: http://www.p3cars.com/vag-install/ towards the bottom of the page tells you how to calibrate for ambient conditions. (Cal.B)

I will try this during lunch break. Im guessing this is the culprit