PDA

View Full Version : pulled fenderes



A4SUM
05-16-2005, 12:12 AM
What are some good shops in socal that pull fenders and how much $ am i looking at? My goal is to fit 19 X 9.5's in the rear and probably just go with 19 X 8.5 in the front. how much sould i need to get pulled.

G-low
05-16-2005, 06:17 PM
from what i understand you can run that setup with just rolling you fenders depending on the offset, tire size and drop

Starting
05-16-2005, 06:25 PM
i have heard you can but i tried to fit 9.5 in the rear and didnt see how without hitting the fender. I beleive the offset was 42 so i had room for a spacer, but I was hitting the suspension and would have to move the wheel out at least 2 inches. I don't see how people are running them with an aggressive drop without a super streched tire or the wheel sticking out.

TomRitt18944
05-17-2005, 03:27 AM
yea that should fit. I run 9" wide all around with 235's

jrodmk2
05-17-2005, 08:02 AM
tom.
what is your offset?

A4SUM
05-18-2005, 10:40 PM
what offset would i need to run 9's all around? i saw Europrojektz car in eurotuner and it looks clean with pulled fenders. any good shops?

agravic 2.0
05-19-2005, 03:09 AM
depends on your wheel's offsets. you can probably have A1 trim your fenders and trim the plastic liner a bit. give wayne a call 714 848 3001

TomRitt18944
05-19-2005, 01:30 PM
I have no idea onj my offset. I looked and researched everywhere but I dunno. My wheels are the only ones in this size on an audi so I'm not sure