PDA

View Full Version : Custom drag disk



M-Hood
05-15-2012, 01:44 PM
Well we just got back from Clutch Masters to pick up a new custom disk for my FX850 Super Single, hope to get it back in the car tonight or tomorrow. Just picked up my rebuilt transmission on Friday, so it is game time.

Custom Sintered Iron disk with a sprung hub. Have to say thanks to the workers at CM that put in the extra time to make this clutch disk.
http://px6.streetfire.net/0002/33/33/2053333_600.jpg
http://px6.streetfire.net/0002/33/23/2053332_600.jpg

Sales@RAI
05-15-2012, 01:52 PM
send me one to test! for free. lol.

M-Hood
05-15-2012, 02:02 PM
send me one to test! for free. lol.

You heed to worry about getting your car running first. [;)]

mtg729
05-15-2012, 06:47 PM
240mm? 228? or is it only compatable with a CM flywheel similar to the fx750/850 twin disks?

Sales@RAI
05-16-2012, 05:44 AM
216mm = 8.5 inches, hence FX "850" [;)]

M-Hood
05-16-2012, 06:43 AM
240mm? 228? or is it only compatable with a CM flywheel similar to the fx750/850 twin disks?

For the 850. I am sure they could do it to a 725 sintered iron disk too. Just sucks that it isn't possible to run 2 sprung hubs on the CM 725/850 series twin plate setups.

Haenszel20v
05-16-2012, 06:50 AM
Very cool. I've been over-and-above happy with my 850. Good to see they're still expanding options.

M-Hood
05-16-2012, 06:55 AM
Very cool. I've been over-and-above happy with my 850. Good to see they're still expanding options.

I had a fun time getting them to do this disk but finally got them to give in. [>_<]

If it turns out to work well for me they said they would be willing to do this type of a disk for the public.

mtg729
05-16-2012, 09:05 AM
216mm = 8.5 inches, hence FX "850" [;)]


For the 850. I am sure they could do it to a 725 sintered iron disk too. Just sucks that it isn't possible to run 2 sprung hubs on the CM 725/850 series twin plate setups.

Gotcha. Thanks guys!