PDA

View Full Version : DIY painted lowers question



chaua1
05-06-2005, 08:14 PM
I was thinking of doing this myself next week. But first, I wanted to how are your painted lowers holding up?

If you could, please say if it was done professionally or not, how long have you had it, and how's the paint holding up.

Thanks in advance.

flyinb501
05-07-2005, 12:03 AM
I'm doin mine next week, but I live in Arizona, and it never rains or snows here so I'm sure they will be fine. If your drivin in the snow, might be a different story.

euro3b
05-07-2005, 09:24 AM
You are going to need to buy a certain chemical to put on the rubber prior to painting. This chemical will open up the pores on the rubber to absorb the paint alot better and to with stand time and abuse.

If you can hold off, I can get you then name of this chemical to use, my buddy put it on mine and they haven’t peeled or chipped on over 4 months.

Rich [:)]

EuroA4
05-07-2005, 09:25 AM
its just an adhesive promoter...if you paint the soft lower door trim you'll need to use a flex additive though.

Starting
05-07-2005, 10:01 AM
Painted mine almost a year ago and is holding up fine. I'm in NJ. Painted my grills too though they have chipped alot due to all the highway driving I do.

mlo517
05-07-2005, 11:35 AM
^^^^^did you get new moldings or just paint over the stock ones? Can i see some upclose pics of your painted sides??????

Starting
05-07-2005, 12:59 PM
i just painted over the stock. check my audi world pic poster, name is starting nothing

IKE20VA4
05-07-2005, 11:40 PM
I just did mine myself tonight and they are holding up great so far! [:D]

I used a plastic adhesion promoter from autozone as my primer then 4 coats color and 4 clear coats!

It looks soo much better than the black already!!
I can't wait to do the front and rear valences tomorrow!

flyinb501
05-08-2005, 12:23 PM
You gotta post some pics when your done!

joeya103
05-08-2005, 02:11 PM
i painted mine last summer, and they've been holding up great. if you do it right, there should be no problem.

Even if it starts to chip a bit, I can always do it again...better than driving around with black plastic pieces down there IMHO

jones3000
05-08-2005, 08:31 PM
on my second year. professionally painted. No chipping.

IKE20VA4
05-08-2005, 10:36 PM
here is my progress on the sides

http://img.photobucket.com/albums/v349/20VTURBO/Painting%20Lowers/DSCF07362.jpg
http://img.photobucket.com/albums/v349/20VTURBO/Painting%20Lowers/DSCF07372.jpg
http://img.photobucket.com/albums/v349/20VTURBO/Painting%20Lowers/DSCF07072.jpg
http://img.photobucket.com/albums/v349/20VTURBO/Painting%20Lowers/DSCF07382.jpg
http://img.photobucket.com/albums/v349/20VTURBO/Painting%20Lowers/DSCF07392.jpg

Used 2 6oz. cans on each side and 1 12oz. can of clear

OutkastSL
05-08-2005, 11:32 PM
good work, it looks great!!!

Poopie
05-09-2005, 01:42 PM
Where are you getting the colors? Audi sells aplications for brushes, do you just put themin a hvlp air brush?