PDA

View Full Version : Quick Valeo Ecode question regarding turn signal connection



MDM_A4
04-20-2005, 07:47 AM
Just wondering if anyone knows where I can get a 2 prong connector to use when installing my Valeo ecodes. I know that I can force the pieces to fit, but wanted to install a piece that fits the euro spec ecode turn signal housing.

I have seen some postings on this, but can't find anything using SEARCH. Thanks in advance.

MDM_A4
04-20-2005, 12:01 PM
What, no love? Please help.

Kurzer
04-20-2005, 12:40 PM
Are you talking about the plastic bulb holder? You can just toss that one and use your original holder, it will twist into the housing.

G18
04-20-2005, 01:02 PM
stock plastic holder will fit fine, shouldnt have to force pieces to fit. i used stock ones in mine and think lots of other people have too.

i think my ecodes came with the euro bulb holders.

Yuikio
04-20-2005, 05:16 PM
Stock one should fit fine...mine did and I haven't had any problems.

JMG
04-20-2005, 05:50 PM
iirc the passenger side blinker had problems fitting.. The three pegs do not line up perfectly. I believe you have to line up the bigger peg and one of the smaller ones, insert then twist to line up the remaining peg. Or was it the other way around?

MDM_A4
04-21-2005, 05:39 AM
Great! Thanks for the help. I will give it a go.

IndieRockSteve
04-21-2005, 01:20 PM
mine wasn't an exact match for the hole pattern, but with a little bit of work it slips in and holds fine.